Skip to content
My Water Damage and Restoration High Point logo
A restoration contractor carrying drying equipment up a driveway from an open service van.

Structural Drying & Rebuild

High Point, NC Water Damage Restoration

Ask for extraction, drying to a measured standard, and the rebuild after. One call routes homes in High Point and the rest of North Carolina to an independent local pro.

Call Now: (833) 243-4415 See Services

Independent local pros · scoped on site, no obligation

  • Standing water answered at any hour
  • Routing by city, to contractors who work independently
  • The visit produces the scope and the quote
  • S500 is the drying standard to hold a contractor to

  • 24/7 emergency response

    Standing water does not wait for business hours, and neither does the number.

  • No lead form

    The pro who visits is the pro who quotes; nothing is resold.

A referral network of independent water damage contractors, reached through one number, in every state.

Call (833) 243-4415
A contractor showing a homeowner a tablet at the door, explaining what has to come out and what can dry in place.
At the door: what the meters found, what it means, and what leaves the building.

From standing water to a dry structure

This is the order IICRC S500 describes, and the order matters more than the machines. Each stage belongs to the contractor, and each one governs the stage after it.

  1. Step 1: Stop and remove

    The source is shut off, then free water is pumped and extracted. Every hour water stands, it climbs further into drywall and subfloor, so this stage sets the size of everything after it.

  2. Step 2: Open and map

    Baseboard, wet drywall and soaked insulation come out, and meters read the material behind them. The wet edge is marked where the moisture stops, not where the stain does.

  3. Step 3: Dry to a number

    Air movers and dehumidifiers run as a sealed system, and the same points are read daily. The equipment leaves when the readings reach the dry standard for that material, not on a set day.

  4. Step 4: Close up

    Rebuild starts only after the structure is confirmed dry. Insulation, drywall and finishes go back over an assembly that will not feed anything later.

Drying a High Point building: what it takes

High Point homeowners reach an independent local contractor for water damage restoration whether the house is downtown or out in Windchase Townhomes and Foxcroft Townhomes. The chimneys here are masonry built against the outside wall, a large cold mass attached to the side of a warm building.

The local building stock

Ask when the houses in High Point were built and the answer is 1989 at the median, 51.5 percent of them finished by 1990. Around a median of 1989 with about half the stock older, the fireplaces were built with a masonry chimney on the outside of the wall rather than within the plan, so there is a substantial mass of brick and block standing against the building and exposed on three sides to the weather.

What the weather does to a drying run

On the 1991–2020 normals, High Point gets 48.27 inches a year with August heaviest at 5.06, and the drying season runs from a 41.7-degree January to a 79.4-degree July; both figures recorded at HIGH PT, 2 miles away. August is the wettest month at over five inches of a forty-eight inch year with only one month averaging a low below freezing, so the wet season is warm and long; masonry on the outside of a building takes that water into its depth and gives it back slowly against the wall it is attached to.

Where High Point losses usually finish

  • A masonry mass on the outside of the wall, so the building has a cold wet element permanently attached to it
  • Brick that absorbs through its depth, so the chimney holds water long after the rain and feeds the junction with the wall
  • A junction between masonry and frame that moves differently, so the joint between them opens over time

Water Damage Restoration services in High Point

Begin with the wet material. From there it is extraction, structural drying, and - where drying stopped too soon - inspection and remediation, all by independent High Point contractors.

Water damage restoration

Mold

Areas covered around High Point

One of several Water Damage Restoration pages for North Carolina: see the full list.

Frequently asked questions

Why is the wall beside the fireplace always the damp one?

Because of what is attached to it. An external chimney is a large mass of brick exposed on three sides, and it takes up a great deal of water and releases it slowly, much of it into the junction with the wall it is built against. That wall is being fed by the chimney rather than by anything indoors.

Does the chimney have to dry before the wall will?

Effectively, yes, and that sets the schedule. Masonry of that thickness releases from its faces over weeks rather than days, so a wall dried and closed while the chimney beside it is still loaded will come back. Readings are taken on the masonry as well as on the framing.

Does the chimney pull away from the wall over time?

It opens, and then it lets water in as well as out. Brick and timber frame move differently through a year of temperature and moisture, so the junction between a chimney and the wall gradually works loose, which turns a slow absorption problem into a direct route. That joint is inspected along its height.

High Point, NC

Wet floor in High Point?

One free call reaches a local contractor who can get equipment running today. No obligation, no lead form.

Call (833) 243-4415

Independent local pros · scoped on site, no obligation

Say where the water is and what it touched. The call routes to an independent pro covering your area; there is no form to fill and no callback queue.

  • What is wet: carpet, hardwood, drywall, a ceiling, a basement floor
  • Whether the water is still coming, standing, or already gone into the floor
  • How long it has been there, as best you can tell
  • Your city, so the call routes to a contractor who covers it
Call a Local Pro — (833) 243-4415