After the drying
Mold Inspection & Testing in Irving, TX
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Both bathrooms are wet. Are there two problems?
Usually one, in the wall between them. These plans put two bathrooms back to back so the pipework serves both from a single chase, and anything that fails in there wets the board on both faces. The room that shows it first is simply the one with the more absorbent finish, not the one with the fault.
Which side gets opened?
Whichever costs less to put back, and it is worth deciding deliberately. Both faces are usually tiled, so the choice comes down to which tile can be matched and which fittings can be moved. Probe readings are taken on both sides first so the opening is made where the water actually is rather than where it is convenient.
How long does a chase like that take to dry?
Four to seven days once it is open, longer if it ran for a while before anyone noticed. The cavity is narrow and enclosed on both faces, so nothing happens until it is opened, and then it comes down reasonably quickly with air directed into it. The framing is read rather than the board.
These questions come from the Irving page.