Skip to content
My Water Damage and Restoration Fort Worth logo
Drying equipment coming off a van in front of a house the morning after a storm, tarps still on the roof.

24/7 Emergency

Storm & Flood Damage Recovery in Fort Worth, TX

The opening is closed, the water is extracted, materials floodwater touched come out, and the structure is dried and rebuilt in that order. The opening is closed first, with tarps or board-up, so the building stops taking on water. Floodwater is extracted, and the porous materials it touched come out rather than dry, since it crossed ground outside. The structure is dried and re-read, and the rebuild waits until the readings and the roof both allow it.

No obligation: the assessment comes before any scope

Often needed alongside

  • Emergency Water Extraction

    Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

  • Sewage & Contaminated Water Cleanup

    Sewage and black-water losses are contained, the materials the water touched are removed and disposed of, hard surfaces are disinfected, and the space is dried to a reading.

A contractor at the front door with a homeowner after a storm, sorting what can be dried from what has to go.
The assessment happens on site, not over the phone.

Frequently asked questions

Why would anybody water a foundation?

To keep the clay under it at a steady moisture content. This soil shrinks as it dries and swells as it wets, and a slab sitting on it moves accordingly. Keeping the perimeter evenly damp through a hot summer stops the edges dropping while the middle stays put, which is what cracks a slab.

Can it be overdone?

Easily, and that is the other half of the problem. A soaker running too long or too close puts saturated ground against the foundation and the wall above it, which produces damp at the base of walls, wet crawl or slab edges, and swelling that lifts the perimeter. Even and moderate is the aim rather than plentiful.

How far from the wall should the hose sit?

Twelve to eighteen inches out, not against the brick. A hose laid tight to the wall wets the masonry itself and the backfill rather than the soil that supports the slab edge, which is the part that matters. Buried a little and set on a timer for short frequent runs is the usual advice here.

Read it with the local conditions on the Fort Worth page.

Need storm & flood recovery in Fort Worth now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415