Serving Fort Worth
Ceiling & Roof Leak Water Damage Repair in Fort Worth, TX
The leak is traced above the stain and corrected, wet insulation comes out, the cavity is dried to a reading, and only then is the ceiling repaired. The leak is traced uphill from the stain and corrected before anything else. Soaked insulation comes out of the cavity, the framing and the back of the ceiling are dried and read to the dry standard, and only then is the ceiling repaired and painted, so the stain does not return through new paint.
The pro who inspects is the pro who quotes
Often needed alongside
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
Frequently asked questions
Why would anybody water a foundation?
To keep the clay under it at a steady moisture content. This soil shrinks as it dries and swells as it wets, and a slab sitting on it moves accordingly. Keeping the perimeter evenly damp through a hot summer stops the edges dropping while the middle stays put, which is what cracks a slab.
Can it be overdone?
Easily, and that is the other half of the problem. A soaker running too long or too close puts saturated ground against the foundation and the wall above it, which produces damp at the base of walls, wet crawl or slab edges, and swelling that lifts the perimeter. Even and moderate is the aim rather than plentiful.
How far from the wall should the hose sit?
Twelve to eighteen inches out, not against the brick. A hose laid tight to the wall wets the masonry itself and the backfill rather than the soil that supports the slab edge, which is the part that matters. Buried a little and set on a timer for short frequent runs is the usual advice here.
Read it with the local conditions on the Fort Worth page.