After the drying
Mold Inspection & Testing in Austin, TX
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What gets opened after a tank fails upstairs?
More than the ceiling under it. Fifty gallons arriving at once runs along the top plates and down inside the walls before it comes through, so the cavities on both floors are read and opened where they are wet. The ceiling is the obvious part and rarely the largest part of the scope.
Is a summer loss quicker to dry here than a winter one?
The ceiling itself, yes. With the warm season in the mid-nineties an attic runs well above the house, so the top of the board dries hard from above without any equipment at all. What does not speed up is the wall cavities below, which are inside the cooled part of the building and set the real length of the job.
Why was the pan no help?
Because a pan only works if its drain does, and that line is almost never tested after the day it was fitted. It blocks, or it was never carried through to the outside, so the pan fills and overflows in the first minutes of a failure. It is checked as part of the repair rather than trusted.
The same questions, in context, on the Austin city page.