Skip to content
My Water Damage and Restoration Austin logo
Drying equipment coming off a van in front of a house the morning after a storm, tarps still on the roof.

24/7 Emergency

Storm & Flood Damage Recovery in Austin, TX

The opening is closed, the water is extracted, materials floodwater touched come out, and the structure is dried and rebuilt in that order. The opening is closed first, with tarps or board-up, so the building stops taking on water. Floodwater is extracted, and the porous materials it touched come out rather than dry, since it crossed ground outside. The structure is dried and re-read, and the rebuild waits until the readings and the roof both allow it.

The pro who inspects is the pro who quotes

Often needed alongside

  • Emergency Water Extraction

    Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

  • Sewage & Contaminated Water Cleanup

    Sewage and black-water losses are contained, the materials the water touched are removed and disposed of, hard surfaces are disinfected, and the space is dried to a reading.

A contractor at the front door with a homeowner after a storm, sorting what can be dried from what has to go.
The assessment happens on site, not over the phone.

Frequently asked questions

What gets opened after a tank fails upstairs?

More than the ceiling under it. Fifty gallons arriving at once runs along the top plates and down inside the walls before it comes through, so the cavities on both floors are read and opened where they are wet. The ceiling is the obvious part and rarely the largest part of the scope.

Is a summer loss quicker to dry here than a winter one?

The ceiling itself, yes. With the warm season in the mid-nineties an attic runs well above the house, so the top of the board dries hard from above without any equipment at all. What does not speed up is the wall cavities below, which are inside the cooled part of the building and set the real length of the job.

Why was the pan no help?

Because a pan only works if its drain does, and that line is almost never tested after the day it was fitted. It blocks, or it was never carried through to the outside, so the pan fills and overflows in the first minutes of a failure. It is checked as part of the repair rather than trusted.

The same questions, in context, on the Austin city page.

Need storm & flood recovery in Austin now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415