Serving Clovis
Structural Drying & Dehumidification in Clovis, NM
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material. The wet area is sealed, air movers and dehumidifiers run as one system, and the material is read at marked points every day against a dry standard from an unaffected room. The equipment leaves on the readings rather than on a date, and the final readings are logged so the rebuild starts on a documented dry structure.
The pro who inspects is the pro who quotes
Often needed alongside
- Emergency Water Extraction
Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
Frequently asked questions
The heater is outside. Why is a bedroom wall wet?
Because the closet shares that wall. There is no drainage in a closet of this kind, so water from a failed tank or connection runs along the floor and into the base of the wall it stands against, which is a finished room on the other side. The room is often the first place anybody notices anything.
What is opened to dry it?
The wall base on the room side, usually low and along the run. That gives access to the plate and the cavity, which is where the water went. The closet side is also checked, but drying is normally done from inside where there is a chamber to work in and where the material that matters is.
Why did it go unnoticed for so long?
Because the outside of the wall dries instantly in this air and shows nothing, while the cavity behind the board keeps the water. There is no puddle to find and no stain outside. These are usually discovered by the room, by the bill or by the heater failing to keep up, which is well after it started.
These questions come from the Clovis page.