After the drying
Mold Inspection & Testing in Clovis, NM
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The heater is outside. Why is a bedroom wall wet?
Because the closet shares that wall. There is no drainage in a closet of this kind, so water from a failed tank or connection runs along the floor and into the base of the wall it stands against, which is a finished room on the other side. The room is often the first place anybody notices anything.
What is opened to dry it?
The wall base on the room side, usually low and along the run. That gives access to the plate and the cavity, which is where the water went. The closet side is also checked, but drying is normally done from inside where there is a chamber to work in and where the material that matters is.
Why did it go unnoticed for so long?
Because the outside of the wall dries instantly in this air and shows nothing, while the cavity behind the board keeps the water. There is no puddle to find and no stain outside. These are usually discovered by the room, by the bill or by the heater failing to keep up, which is well after it started.
These questions come from the Clovis page.