Serving Jackson
Structural Drying & Dehumidification in Jackson, MS
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material. The wet area is sealed, air movers and dehumidifiers run as one system, and the material is read at marked points every day against a dry standard from an unaffected room. The equipment leaves on the readings rather than on a date, and the final readings are logged so the rebuild starts on a documented dry structure.
Quoted on site by the contractor who visits
Often needed alongside
- Emergency Water Extraction
Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
Frequently asked questions
How long does a slab leak under tile take to dry once it is found?
Two weeks is not unusual. By the time a slab leak shows through tile it has usually run for weeks, so the concrete is saturated and gives its water up slowly. The contractor lifts the floor over the wet area, dries the slab with mats and a sealed run, and the tile goes back only after the plumbing repair and the readings are both done.
Does the crawl space have to be dried if the leak was in the kitchen?
Usually, yes. Water that reached the floor runs through the subfloor into the crawl, and a low crawl space here is damp most of the year already. The contractor removes the wet insulation between the joists, seals and dehumidifies the crawl, and reads the subfloor from below as well as from the kitchen before the floor is closed up.
Why is the drywall being cut when the water was only on the floor?
Because it wicked. Paper-faced drywall draws water up from the floor and softens from behind, and behind brick veneer it also collects along the bottom plate where nothing reads it. The contractor cuts at a standard height, dries the framing and the plate to a reading, and the new sheet goes on only when the cavity is dry.
This FAQ belongs to the Jackson page; it is repeated here.