After the drying
Mold Inspection & Testing in Jackson, MS
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How long does a slab leak under tile take to dry once it is found?
Two weeks is not unusual. By the time a slab leak shows through tile it has usually run for weeks, so the concrete is saturated and gives its water up slowly. The contractor lifts the floor over the wet area, dries the slab with mats and a sealed run, and the tile goes back only after the plumbing repair and the readings are both done.
Does the crawl space have to be dried if the leak was in the kitchen?
Usually, yes. Water that reached the floor runs through the subfloor into the crawl, and a low crawl space here is damp most of the year already. The contractor removes the wet insulation between the joists, seals and dehumidifies the crawl, and reads the subfloor from below as well as from the kitchen before the floor is closed up.
Why is the drywall being cut when the water was only on the floor?
Because it wicked. Paper-faced drywall draws water up from the floor and softens from behind, and behind brick veneer it also collects along the bottom plate where nothing reads it. The contractor cuts at a standard height, dries the framing and the plate to a reading, and the new sheet goes on only when the cavity is dry.
This FAQ belongs to the Jackson page; it is repeated here.