After the drying
Mold Inspection & Testing in Exeter, CA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How is the wall wet when it has barely rained?
Because the water is coming from the ground rather than the sky. The render is carried down into the soil instead of stopping clear of it, so it is in continuous contact with damp earth and draws moisture up into the wall. With twelve inches of rain a year, that is the larger source by a distance.
Where does the damage show first?
At the bottom plate and the base of the board inside, because that is the lowest timber in the wall and the moisture is arriving from below. The wall reads dry at hand height and wet at the floor, which is the opposite of what a roof or window problem produces.
Does drying it solve the problem?
Only until the ground next gets wet. The wall comes back readily enough in air this dry, but the render is still in the soil and will draw again, so the base of the wall has to be separated from the ground for the repair to hold. That is a construction change rather than part of the drying.
These questions come from the Exeter page.