Skip to content
My Water Damage and Restoration New Braunfels logo
A restoration contractor carrying drying equipment up a driveway from an open service van.

Measured Drying, Then Rebuild

New Braunfels, TX Water Damage Restoration

Extraction, drying to a measured standard, and the rebuild after, for homes across New Braunfels and the rest of Texas. One call reaches an independent local pro.

Call Now: (833) 243-4415 See Services

Scoped on site, not over the phone · no obligation

  • Any hour, including the ones nobody wants to call in
  • City by city routing, never a national crew
  • Whoever inspects is whoever prices the work
  • Ask for drying measured against IICRC S500, not days elapsed

  • 24/7 emergency response

    Any hour of any day, including the holiday weekend it usually happens on.

  • No lead form

    No lead form, no resale: one call, one contractor, one quote.

A referral network of independent water damage contractors, reached through one number, in every state.

Call (833) 243-4415
A contractor showing a homeowner a tablet at the door, explaining what has to come out and what can dry in place.
Readings, then scope, then removal - in that order, agreed at the door.

The four stages of a drying job

What the IICRC S500 standard lays out, in sequence. The equipment is the easy part; the order is what decides how much of each later stage there is to do.

  1. Step 1: Stop and remove

    The source is shut off, then free water is pumped and extracted. Every hour water stands, it climbs further into drywall and subfloor, so this stage sets the size of everything after it.

  2. Step 2: Open and map

    Baseboard, wet drywall and soaked insulation come out, and meters read the material behind them. The wet edge is marked where the moisture stops, not where the stain does.

  3. Step 3: Dry to a number

    Air movers and dehumidifiers run as a sealed system, and the same points are read daily. The equipment leaves when the readings reach the dry standard for that material, not on a set day.

  4. Step 4: Close up

    Rebuild starts only after the structure is confirmed dry. Insulation, drywall and finishes go back over an assembly that will not feed anything later.

New Braunfels: what the drying job runs into

Water damage restoration by an independent local contractor covers New Braunfels together with Old Mill Crossing and Green Valley Estates. A heavy timber frame filled with limestone rubble and lime mortar is how the historic core of this town was built.

How these houses are built

28.6 percent of New Braunfels's housing was standing before 1990, around a median build year of 2006, and that era decides what a contractor finds once the drywall is off. With a median of 2006 and under three in ten houses older, the historic core carries a distinctive German building tradition where a heavy timber frame is infilled with limestone rubble and lime mortar between the members.

The climate a job dries in

Drying here is a August job at one pace and a January job at another, 83 degrees against 49.3; the 35.42 inches a year peak in May at 4.42, rain recorded at NEW BRAUNFELS 0.1 ENE 0.4 miles away and temperatures at NEW BRAUNFELS 4 miles away. May is the wettest month at 4.42 inches of a 35-inch year with no freezing month and July highs above 93, so the walls take heavy spring rain and then a long hot summer; lime and timber together need to breathe through both.

The way a loss ends here

  • Timber and masonry sharing one wall, so the two materials move against each other
  • Lime mortar in the panels, so modern hard repairs trap water rather than letting it out
  • Structural frame inside the wall, so what gets wet is the building rather than a finish

Water Damage Restoration services in New Braunfels

Start with what is wet. My Water Damage and Restoration routes you to independent New Braunfels contractors for extraction and drying, with mold inspection and remediation as the last stage of the same job.

Water damage restoration

Mold

Areas covered around New Braunfels

Texas cities covered are listed on the state page.

Frequently asked questions

What are these walls made of?

A heavy timber frame with the panels between the posts filled with limestone rubble set in lime mortar. The frame carries the building and the infill closes it in, so a single wall is doing two jobs with two quite different materials.

Why does modern repair material cause trouble?

Because lime lets a wall dry and cement does not. Repointing the panels in hard modern mortar seals the moisture in against the timber frame, so the wall stops breathing and the posts inside it stay wet. The repair causes the decay.

How should one of these be dried?

Slowly and from both faces, with the finishes opened rather than sealed. Driving heat at a wall like this shrinks the timber away from the infill and opens the joints, so the work is patient and the readings are taken into the wall.

New Braunfels, TX

Standing water in New Braunfels?

The call is free and it reaches a contractor who can have equipment running today. Nothing is owed for asking.

Call (833) 243-4415

Scoped on site, not over the phone · no obligation

Say where the water is and what it touched. The call routes to an independent pro covering your area; there is no form to fill and no callback queue.

  • What is wet: carpet, hardwood, drywall, a ceiling, a basement floor
  • Whether the water is still coming, standing, or already gone into the floor
  • How long it has been there, as best you can tell
  • Your city, so the call routes to a contractor who covers it
Call a Local Pro — (833) 243-4415