Contained removal
Mold Removal & Remediation in Lewisville, TX
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
No obligation: the assessment comes before any scope
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is the ledge at the bottom of the brick?
Part of the slab. The floor was poured with a turned-down edge and a shelf formed into it to carry the weight of the masonry, so there is a concrete step running round the building under the brick. Anything draining down the back of that wall arrives on it.
Where is it supposed to go from there?
Out through openings left in the bottom course. That is the whole design: water gets behind brick, runs down and leaves at the ledge. When those openings are blocked by mortar or by landscaping built up against the wall, the water has nowhere to go and stands on the shelf instead.
What does standing water on the ledge reach?
The bottom plate of the wall above it and the edge of the slab itself. That is the lowest timber in the building and it is being fed from the outside, so the damage starts there and works up, and the room inside reads dry at hand height while the base is wet.
Read it with the local conditions on the Lewisville page.