Serving Amsterdam
Structural Drying & Dehumidification in Amsterdam, NY
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material. The wet area is sealed, air movers and dehumidifiers run as one system, and the material is read at marked points every day against a dry standard from an unaffected room. The equipment leaves on the readings rather than on a date, and the final readings are logged so the rebuild starts on a documented dry structure.
Quoted on site by the contractor who visits
Often needed alongside
- Emergency Water Extraction
Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
Frequently asked questions
What is the shaft between the buildings for?
Light and air to the middle rooms. The buildings were put up close together and a narrow gap was left so the rooms that would otherwise have no window could have one. It runs the full height with walls on all sides and a drain at the bottom.
Why does it cause trouble?
Because everything that falls into it stays. Rain, leaves and anything dropped from a window collect at the bottom, the one drain there blocks, and the shaft has no sun and no air movement to dry it. It becomes a wet well between two buildings.
How does the water get inside?
Through the windows that open onto it, mostly, and through the walls at the bottom where the water stands. A shaft that has filled is holding water against masonry that was never detailed to be below ground, which is what it effectively becomes.
This FAQ belongs to the Amsterdam page; it is repeated here.