Serving Wilson
Structural Drying & Dehumidification in Wilson, NC
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material. The wet area is sealed, air movers and dehumidifiers run as one system, and the material is read at marked points every day against a dry standard from an unaffected room. The equipment leaves on the readings rather than on a date, and the final readings are logged so the rebuild starts on a documented dry structure.
No obligation: the assessment comes before any scope
Often needed alongside
- Emergency Water Extraction
Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
Frequently asked questions
What is missing at the rake?
A metal edge under the covering that projects past the trim and turns down. Its whole purpose is to make water leave the roof rather than curl back under the shingle and run onto the board below. On a lot of this stock the shingles simply overhang the trim and the water follows the underside.
Why does it matter more here than elsewhere?
Because the rain arrives sideways. Tropical remnants push water up the slope and across the gable rather than straight down, so the roof edge is being wetted from below as well as above. In a still climate the same detail leaks far less.
Is it fixable without stripping the roof?
Along the rake, yes, in most cases. The edge can be slid under the first course and fastened, which is a day's work on a house rather than a re-roof. It is worth doing at the same time as any repainting of the trim, since the trim is usually what prompted the question.
These questions come from the Wilson page.