After the drying
Mold Inspection & Testing in Gastonia, NC
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Water got into the ducts under the floor. Can they be dried out?
Fiberboard ducting generally cannot. It is a rigid fiber panel with a lining, and once it is soaked it loses its shape and the lining separates, so a wet run is cut out and replaced. Metal ducting in the same position can often be dried and cleaned, which is why the material is established early.
Should the system be switched off straight away?
Yes, before anything else. A blower running with wet ducting under the floor takes moisture from the crawl space and delivers it to every room, so the whole house gets wetter while the system is helping. It stays off for the duration and the drying equipment conditions the building instead.
What else under the floor comes out?
Insulation between the joists and any ground sheet holding water. Wet batt sags and keeps the subfloor damp, and a sheet with water on top of it is a reservoir feeding the space. Both come out early so that the joists and decking can be read with pins, which is what the schedule is actually built on.
This FAQ belongs to the Gastonia page; it is repeated here.