After the drying
Mold Inspection & Testing in Brookhaven, MS
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How is a wet wall found behind paneling?
By taking readings at the joints and at the bottom edge rather than off the face. The sheet itself is thin and does not carry moisture the way board does, so a surface meter reads the panel and not the wall, and pins have to go past it. Where the readings are ambiguous the panel comes off.
Does the paneling come off or stay?
It usually comes off, because it is what stands between the equipment and the wall. Some of it can be lifted carefully and put back, which is worth doing where it matches nothing available now. What cannot happen is leaving it up and drying the room, because the cavity behind it will not change.
Is there a better or worse time of year for this?
Not really, and that is the difficulty. The wettest month is January, but it never gets cold enough here for the indoor air to become genuinely dry, so there is no season in which the building helps. A closed wall is dried by equipment in exactly the same way in January as in July.
These questions come from the Brookhaven page.