Skip to content
My Water Damage and Restoration Plymouth logo
Containment poles and a negative-air machine coming off a van, the setup for removing growth without spreading it.

Contained removal

Mold Removal & Remediation in Plymouth, MN

Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.

Quoted on site by the contractor who visits

Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.

Often needed alongside

  • Mold Inspection & Testing

    An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A contractor at the door walking a homeowner through what comes out, what gets cleaned, and when the wall closes up.
A contractor setting expectations with the homeowner.

Frequently asked questions

How does a covered well end up full of water?

Because the cover is not sealed and it works both ways. Blowing snow gets under the edge through the winter and then melts, and the dome that kept most of it out also stops what has collected from evaporating away. The well holds it against the window instead.

Why does this take a whole season to show?

Because nobody looks. The cover is opaque with snow on it for months, the window is in a basement nobody uses in winter, and the melting is slow rather than dramatic. By the time the frame and the sill show anything, they have been wet since December.

What is worth changing?

Checking under the cover a couple of times over the winter, which is the whole of it. The well and the cover are both doing their job most of the time, and the problem is that nobody has any reason to look. A cover that can be lifted easily is worth more than one that seals perfectly.

These questions come from the Plymouth page.

Need mold remediation in Plymouth now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415