Skip to content
My Water Damage and Restoration Plymouth logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Plymouth, MN

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

No obligation: the assessment comes before any scope

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
An independent contractor, walking the homeowner through what he found.

Frequently asked questions

How does a covered well end up full of water?

Because the cover is not sealed and it works both ways. Blowing snow gets under the edge through the winter and then melts, and the dome that kept most of it out also stops what has collected from evaporating away. The well holds it against the window instead.

Why does this take a whole season to show?

Because nobody looks. The cover is opaque with snow on it for months, the window is in a basement nobody uses in winter, and the melting is slow rather than dramatic. By the time the frame and the sill show anything, they have been wet since December.

What is worth changing?

Checking under the cover a couple of times over the winter, which is the whole of it. The well and the cover are both doing their job most of the time, and the problem is that nobody has any reason to look. A cover that can be lifted easily is worth more than one that seals perfectly.

These questions come from the Plymouth page.

Need mold inspection & testing in Plymouth now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415