Contained removal
Mold Removal & Remediation in Boston, MA
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
Quoted on site by the contractor who visits
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The unit above leaked through the plaster ceiling. What is the drying job?
The joist space between the two units and the plaster on both sides of it. The contractor opens the ceiling under the wet area, removes any soaked insulation, dries the cavity with air and dehumidification, and reads the joists and the plaster until both hold the dry standard. The ceiling is patched after that, not before, or the stain returns.
How long does a fieldstone basement take to dry after a December storm?
Longer than a block basement. Fieldstone walls hold water in the mortar and the stone and release it slowly. Once the wet finishes are out, the contractor seals the basement, runs air along the wall base and a dehumidifier sized to the space, and reads the floor and wall daily. Two weeks is common in a wet December.
Can a triple-decker be dried in winter with the heat on?
Yes, and the heat helps. Winter indoor air in Boston is dry, so a sealed room with air movers and a dehumidifier reaches the readings in a few days once the line is repaired. The complication in a triple-decker is that a leak often involves two units, so there are more cavities to read rather than slower ones.
The Boston overview carries this FAQ with the city research.