Skip to content
My Water Damage and Restoration Boston logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Boston, MA

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

No obligation: the assessment comes before any scope

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
An independent contractor, walking the homeowner through what he found.

Frequently asked questions

The unit above leaked through the plaster ceiling. What is the drying job?

The joist space between the two units and the plaster on both sides of it. The contractor opens the ceiling under the wet area, removes any soaked insulation, dries the cavity with air and dehumidification, and reads the joists and the plaster until both hold the dry standard. The ceiling is patched after that, not before, or the stain returns.

How long does a fieldstone basement take to dry after a December storm?

Longer than a block basement. Fieldstone walls hold water in the mortar and the stone and release it slowly. Once the wet finishes are out, the contractor seals the basement, runs air along the wall base and a dehumidifier sized to the space, and reads the floor and wall daily. Two weeks is common in a wet December.

Can a triple-decker be dried in winter with the heat on?

Yes, and the heat helps. Winter indoor air in Boston is dry, so a sealed room with air movers and a dehumidifier reaches the readings in a few days once the line is repaired. The complication in a triple-decker is that a leak often involves two units, so there are more cavities to read rather than slower ones.

The Boston overview carries this FAQ with the city research.

Need mold inspection & testing in Boston now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415