24/7 Emergency
Storm & Flood Damage Recovery in Hilo, HI
The opening is closed, the water is extracted, materials floodwater touched come out, and the structure is dried and rebuilt in that order. The opening is closed first, with tarps or board-up, so the building stops taking on water. Floodwater is extracted, and the porous materials it touched come out rather than dry, since it crossed ground outside. The structure is dried and re-read, and the rebuild waits until the readings and the roof both allow it.
No obligation: the assessment comes before any scope
Often needed alongside
- Emergency Water Extraction
Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
- Sewage & Contaminated Water Cleanup
Sewage and black-water losses are contained, the materials the water touched are removed and disposed of, hard surfaces are disinfected, and the space is dried to a reading.
Frequently asked questions
With this much rain, can a house here actually be dried?
Yes, but only as a closed system. At over 120 inches a year and no cold season, outdoor air never helps and opening the building up works against the job. The affected area is closed off and dehumidified, and readings decide the end. What does not work is any approach that relies on ventilation or on waiting for a dry spell.
The house sits on posts. Where is the drying done?
At the floor framing from below, in most cases. A raised floor puts the joists and subfloor over open ground that stays humid, so that is where the water ends up and where the equipment goes. The space is enclosed as far as practical so the dehumidification has something to work against rather than the whole outdoors.
There is no wall cavity in this house. Is that better or worse?
Better for access, worse for exposure. Single-wall construction means the framing is visible and can be read and dried directly, with no cavity hiding water. But it also means that framing faces the room and the weather with little between, so it re-wets easily and the affected area has to be closed off properly for the drying to hold.
This FAQ belongs to the Hilo page; it is repeated here.