Serving Jackson
Structural Drying & Dehumidification in Jackson, GA
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material. The wet area is sealed, air movers and dehumidifiers run as one system, and the material is read at marked points every day against a dry standard from an unaffected room. The equipment leaves on the readings rather than on a date, and the final readings are logged so the rebuild starts on a documented dry structure.
Quoted on site by the contractor who visits
Often needed alongside
- Emergency Water Extraction
Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
Frequently asked questions
How does the heating system wet the wall?
By shedding ice where it stands. A heat pump forms ice on its outdoor coil in cold weather and melts it off periodically, and that water goes straight down onto the pad and the ground beneath, which is usually right against the foundation. Every cold night adds to it.
Why does this not follow the rain?
Because it is not weather. The unit defrosts when it is cold, so the wall is wettest in a dry cold spell and unaffected by a warm wet one, which is the opposite of what people look for. A wall that is damp in January and fine in a March downpour is describing the unit.
What stops the defrost water reaching the wall?
Getting the discharge away from the wall, which is usually a pad, a gravel bed and a bit of fall rather than anything to do with the unit itself. It is inexpensive and it is the only thing that stops it, since the defrost cycle is doing what it is supposed to.
These questions come from the Jackson page.