After the drying
Mold Inspection & Testing in Tampa, FL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How long does drying take during the afternoon-storm season here?
Longer than a winter job in the same house. Between June and September the outdoor air is loaded with moisture, so the space has to stay sealed and the dehumidifiers work harder for a longer run. A wet floor that would take three or four days in January can take a week in August; the readings decide.
Is a block house dried the same way as a frame house here?
No. A block wall holds water in its cores and is dried by opening the base and pushing air through; a wood-frame wall with drywall usually has the wet sheet cut out and the studs dried directly. Tampa has both kinds side by side, so the contractor confirms the wall type before writing the scope.
The air conditioner leaked into a closet ceiling. What has to come out?
The wet insulation and, usually, the drywall it soaked, and then the cavity is dried before anything closes. Condensate lines back up most in the wet season, when the system runs hardest, and the water sits in the cavity above the stain. The line is cleared or repaired first, then the drying runs to a reading, then the ceiling is patched.
These questions come from the Tampa page.