After the drying
Mold Inspection & Testing in West Haven, CT
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Can a tile floor like this be dried without lifting it?
Very rarely. The tile is set in a thick mortar bed that absorbs a great deal and releases it slowly from one face, and the timber underneath has no air at all. Drying the room above a bed like that reaches the surface and nothing else, so the readings stall a long way from where they need to be.
What is involved in taking it out?
Breaking out rather than lifting. The bed is a solid layer several times the thickness of the tile, bonded to nothing and resting on the structure, so it comes out in pieces and the weight of it is considerable. It is the slowest part of the job and it happens before the drying can properly start.
How is the floor structure underneath assessed?
Once it is exposed, directly, with pins into the subfloor and the joists. Until the bed is off there is no meaningful reading to take, because a meter on the tile reports the bed. That is why nothing about the extent is settled early on a floor like this; it is known only after the removal.
These questions come from the West Haven page.