Skip to content
My Water Damage and Restoration New London logo
A restoration contractor carrying drying equipment up a driveway from an open service van.

Drying to a Measured Standard

New London, CT Water Damage Restoration

Water out first. Structure dried to a number second. Rebuild last. That order holds for New London and the rest of Connecticut, and one call reaches an independent local pro.

Call Now: (833) 243-4415 See Services

The scope comes from the visit · no obligation either way

  • Calls taken at any hour while water is standing
  • Each city routed to contractors working in it
  • The contractor who turns up is the one who quotes
  • IICRC S500: the published standard for the drying stage

  • 24/7 emergency response

    Water emergencies answered around the clock, every day of the year.

  • No lead form

    One call, quoted by the pro who visits. Your details are not sold on.

A referral network of independent water damage contractors, reached through one number, in every state.

Call (833) 243-4415
A contractor showing a homeowner a tablet at the door, explaining what has to come out and what can dry in place.
Meter readings first, then the scope at the door, then anything comes out.

What happens between the call and the rebuild

Four stages, in one order, described by the IICRC S500 standard. The contractor does each; how well each is done decides how much work the next one carries.

  1. Step 1: Stop and remove

    The source is shut off, then free water is pumped and extracted. Every hour water stands, it climbs further into drywall and subfloor, so this stage sets the size of everything after it.

  2. Step 2: Open and map

    Baseboard, wet drywall and soaked insulation come out, and meters read the material behind them. The wet edge is marked where the moisture stops, not where the stain does.

  3. Step 3: Dry to a number

    Air movers and dehumidifiers run as a sealed system, and the same points are read daily. The equipment leaves when the readings reach the dry standard for that material, not on a set day.

  4. Step 4: Close up

    Rebuild starts only after the structure is confirmed dry. Insulation, drywall and finishes go back over an assembly that will not feed anything later.

What a wet building in New London asks of a contractor

New London homeowners reach an independent local contractor for water damage restoration whether the house is downtown or out in Osprey Beach, Ridgewood, and Downtown New London. A coastal city in southeastern Connecticut where 89.7 percent of houses predate 1990 and a 4.99-inch October starts the wet season.

The materials in these houses

89.7 percent of New London's housing was standing before 1990, around a median build year of 1945, and that era decides what a contractor finds once the drywall is off. With a median build year of 1945, the stock is older frame and masonry over stone cellars, so a below-grade loss meets rubble stone walls and heavy timber, both of which hold water far longer than the finishes fastened to them.

Weather that sets the pace

On the 1991–2020 normals, New London gets 50.37 inches a year with October heaviest at 4.99, and the drying season runs from a 30.8-degree January to a 72.3-degree July; rain recorded at NEW LONDON 1.0 NNW 0.8 miles away and temperatures at GROTON NEW LONDON AP 2.5 miles away. October is the wettest month at 4.99 inches and four months sit below freezing with January lows near 23 degrees, so the wettest month comes just ahead of the freeze and leaves a narrow window before the building closes for winter.

How the losses here usually end

  • Rubble stone cellar walls releasing moisture through the joints for days
  • Heavy timber framing holding water in the grain after surfaces read dry
  • October losses running into the heating season before the cellar is finished

Water Damage Restoration services in New London

My Water Damage and Restoration puts the call to independent contractors in New London: extraction, then drying, then the mold stage if the drying stopped short somewhere.

Water damage restoration

Mold

Areas covered around New London

Not the right city? Browse all Connecticut directories.

Frequently asked questions

How long does a stone cellar take to dry?

Longer than anything attached to it, and the joints are the slowest part. Rubble stone and lime mortar hold water deep in the wall and give it up through the face over days. The room can feel finished well before the wall is. Nothing is refastened against it until base readings hold steady, because furring fixed to damp stone traps the moisture behind it.

Does old timber framing dry like modern lumber?

Not at the same pace. Heavy old timber takes water slowly and releases it slowly, so it can still read wet after modern framing in the same space has finished. It generally survives well. Readings are taken in the timber itself rather than at the surface, and the equipment stays until those numbers stop moving.

The loss happened in October. Is that a problem?

It compresses the schedule. October is the wettest month here at nearly five inches and the freeze follows within weeks, so there is a narrow stretch before the building is closed and heated for the winter. Once heating begins the dry indoor air does help, but a cellar left damp when the house closes stays damp a long time.

New London, CT

Water still standing in New London?

Call once, at no cost, and reach a contractor who can be running equipment today. No obligation either way.

Call (833) 243-4415

The scope comes from the visit · no obligation either way

Say where the water is and what it touched. The call routes to an independent pro covering your area; there is no form to fill and no callback queue.

  • What is wet: carpet, hardwood, drywall, a ceiling, a basement floor
  • Whether the water is still coming, standing, or already gone into the floor
  • How long it has been there, as best you can tell
  • Your city, so the call routes to a contractor who covers it
Call a Local Pro — (833) 243-4415