After the drying
Mold Inspection & Testing in Long Beach, CA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Local contractors · findings documented for your claim
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Can a raised wood floor be dried without pulling the finish floor?
Often, if the crawl space is reachable. Air is moved under the joists and the subfloor is read from below, which dries the assembly without lifting the boards above. It depends on how long the water sat and what the finish floor is; a floor that has already cupped badly is usually lifted so the subfloor can be reached directly.
Does plaster over lath have to come out?
Less often than drywall does. Plaster is slower to soften and frequently survives, but the keys squeezed through the lath hold water where nothing can reach them, and the cavity behind is what actually needs drying. Cuts are usually made low on the wall to open the cavity and the plaster above is left in place if it is still sound.
Why is equipment still running under the house?
Because the space under a raised floor is enclosed and still, and it gives up moisture far more slowly than a room does. If the crawl space is closed while the soil and joists are still damp, that moisture moves back up into the floor. Readings are taken below as well as above, and the equipment comes out when both hold.
The same questions, in context, on the Long Beach city page.