Serving Clovis
Structural Drying & Dehumidification in Clovis, CA
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material. The wet area is sealed, air movers and dehumidifiers run as one system, and the material is read at marked points every day against a dry standard from an unaffected room. The equipment leaves on the readings rather than on a date, and the final readings are logged so the rebuild starts on a documented dry structure.
Quoted on site by the contractor who visits
Often needed alongside
- Emergency Water Extraction
Standing water is pumped and extracted around the clock, before it climbs the walls and soaks the subfloor. Same-day response where coverage allows.
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
Frequently asked questions
How can a full pool be leaking?
Because something is replacing the water as it goes. The automatic filler exists to make up evaporation, and it cannot tell the difference between water lost to the air and water lost through a crack in the shell or a failed fitting. The level stays constant while the ground underneath takes a steady supply.
How would anyone spot it?
On the water bill, usually, or as soft ground and settlement on one side of the pool. A useful check is to switch the filler off and mark the level for a day; a pool in this climate loses about a quarter inch to evaporation, and anything much beyond that is going somewhere else.
What does that water do to the house?
It depends on how close the pool is, and here they are usually close. Continuous water into the soil beside a slab softens the ground under the edge of it, and the first sign inside is frequently a crack in the floor or a door that no longer closes rather than anything wet at all.
Read it with the local conditions on the Clovis page.