Skip to content
My Water Damage and Restoration Clovis logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Clovis, CA

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

Independent local assessors · no obligation to proceed

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
Findings first: what is there, and what it will take.

Frequently asked questions

How can a full pool be leaking?

Because something is replacing the water as it goes. The automatic filler exists to make up evaporation, and it cannot tell the difference between water lost to the air and water lost through a crack in the shell or a failed fitting. The level stays constant while the ground underneath takes a steady supply.

How would anyone spot it?

On the water bill, usually, or as soft ground and settlement on one side of the pool. A useful check is to switch the filler off and mark the level for a day; a pool in this climate loses about a quarter inch to evaporation, and anything much beyond that is going somewhere else.

What does that water do to the house?

It depends on how close the pool is, and here they are usually close. Continuous water into the soil beside a slab softens the ground under the edge of it, and the first sign inside is frequently a crack in the floor or a door that no longer closes rather than anything wet at all.

Read it with the local conditions on the Clovis page.

Need mold inspection & testing in Clovis now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415