After the drying
Mold Inspection & Testing in Scottsdale, AZ
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Can a house be dried too quickly?
It can, and it is the more common mistake here. Timber gives up moisture from its surface first, and when the surrounding air is very dry the outside of a board dries and shrinks while the middle is still wet. That is what cups a floor and opens joints in trim, so the rate is controlled rather than pushed.
What is the target reading in a climate like this?
Lower than most, and it is taken from the building rather than from a table. Materials here settle at a low moisture content because the air is dry nearly all year, so a standard borrowed from elsewhere leaves them above where they started. Unaffected timber in the same house is measured and used as the goal.
Why keep equipment running when everything reads dry?
Because the surface reaches the air before the assembly does. In this climate a wall face or a floor board can read dry within a day while the framing and the back of the board are still holding water, and the reading you want is from inside the assembly. Closing up early is what brings a job back.
This FAQ belongs to the Scottsdale page; it is repeated here.