After the drying
Mold Inspection & Testing in Cody, WY
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
A beam got wet. Can it just be replaced?
Rarely without a great deal of work. Exposed timber here is usually structural and finish at the same time, so taking it out means shoring the building and matching a member that will be visible forever afterwards. It is nearly always dried in place instead, which takes longer and is the cheaper outcome by a wide margin.
Why is the drying deliberately slowed down?
To stop it checking. A large solid timber holds moisture deep inside, and air this dry pulls the outer face down far faster than the core can follow. That gradient opens splits along the length of the member, which are permanent and visible. The chamber is held at a controlled humidity rather than driven as low as it will go.
How is a member like that actually read?
With long pins driven well into the section, at several depths, rather than with a surface meter. A face reading on a heavy timber in dry air is meaningless within a day. The numbers that matter come from inside the member, they fall slowly, and the run continues until the readings at depth stop moving.
This FAQ belongs to the Cody page; it is repeated here.