After the drying
Mold Inspection & Testing in Bridgeport, WV
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is under the aluminum or vinyl?
Usually the original wood siding, still in place. Re-cladding a house rarely involved taking the old surface off, so there are two skins on the wall with a gap between them, and the inner one is sealed in behind a surface that passes nothing. It has not dried properly since the day it was covered.
Does that gap cause the problem or just hide it?
Both. Water getting behind the outer skin runs down between the two claddings and arrives at the bottom of the wall without anything appearing on the surface, and the original siding behind holds what it takes. The void gives the water a route and removes any warning at the same time.
How is the wall assessed?
By taking the outer cladding off along the suspected run, because nothing else answers the question. Readings on the outer surface report the outer surface, and from inside the house there are two layers plus a void in the way. It is slower than it looks and it is the only reliable approach.
This FAQ belongs to the Bridgeport page; it is repeated here.