After the drying
Mold Inspection & Testing in Tacoma, WA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The uphill wall will not come down to the others. Is something still leaking?
Usually not from inside. Dense glacial till holds water and moves it slowly downhill, so the wall with ground against it has a supply from outside that has nothing to do with the original loss. It is read separately and held to a stable trend rather than to the number the other walls reach.
What comes off the wall before drying starts?
Anything fastened to it. Framing, board, insulation and any finish trap moisture against the concrete and make it impossible to read or to move air across. They come off along the wet run, the concrete is exposed, and what goes back afterwards is decided once the wall's behavior through a full wet season is understood.
Is there a better time of year for this kind of job?
Summer, by a wide margin. From July to September the ground dries out, the perched water drops away and the wall finally releases. The same basement worked in January is fighting a charged hillside. Where the work can wait, it is worth scheduling the permanent side of it for the dry months.
The Tacoma overview carries this FAQ with the city research.