Skip to content
My Water Damage and Restoration Olympia logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Olympia, WA

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

No obligation: the assessment comes before any scope

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
An independent contractor, walking the homeowner through what he found.

Frequently asked questions

What is under the downtown?

Fill placed over what were tidal flats, and beneath that a confined aquifer. The water in that aquifer is under pressure, which is why there are artesian wells here that flow without pumping, and it is pressing up under the fill.

Does that change what a sump is doing?

It changes what it is fighting. A pump dealing with rain that has soaked down eventually wins; one dealing with water being pushed up from below is working against a source that does not stop, so it runs continuously rather than cycling.

How can the two be told apart?

By when it runs. Surface water follows the rain with a delay of hours to days; artesian pressure is steady and largely indifferent to the weather. A sump that runs just as hard in August as in November is telling you which it is.

These questions come from the Olympia page.

Need mold inspection & testing in Olympia now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415