After the drying
Mold Inspection & Testing in Essex Junction, VT
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why fit guards to a roof that sheds snow?
Because a metal roof releasing its load at once is dangerous to whatever is beneath it, including people at a door and cars on a drive. The guards hold the snow in place so it melts away gradually instead. It is the right decision for safety and it changes how the roof behaves in winter.
What does holding the snow do?
It keeps a wet mass on the roof for months. Water melting at the warm underside runs down under the snow toward the eaves, where it is colder, and freezes there. That is the same process that produces ice dams on a shingle roof, on a roof type people assume does not get them.
Are the fixings a problem?
They can be. Guards clamped to the seams of a standing-seam roof put no holes in it at all; guards screwed through the panels put a row of penetrations across the slope, each sealed with a washer that ages. On an older installation those are worth looking at when anything else is being done to the roof.
These questions come from the Essex Junction page.