After the drying
Mold Inspection & Testing in Lynchburg, VA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why does the service mast leak?
Because it is a rigid pipe through a roof that moves, with a rubber or lead boot around it. The mast is pulled sideways by the weight of the overhead cable, the boot hardens, and the gap opens. It is one of the most common roof penetrations to fail and one of the least often inspected.
Where does water on the mast end up?
Down the outside of the pipe into the roof space, and then along whatever it lands on. Because the mast continues down inside to the panel, staining sometimes appears near electrical equipment, which is a good reason to treat it as urgent rather than as an ordinary roof leak.
Who repairs a leaking service mast?
A roofer for the flashing, but the utility and an electrician are involved if the mast itself has to move. That is worth knowing before the work is scheduled, because a boot cannot be replaced properly with the mast in the way, and the service usually has to be disconnected for a few hours.
This FAQ belongs to the Lynchburg page; it is repeated here.