After the drying
Mold Inspection & Testing in Temple, TX
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
There is a stain on the ceiling and nothing else. What is the likely source?
A fitting in the cavity above it. Gray poly generally does not burst along the pipe; it fails where the pipe is crimped onto a fitting, and those sit inside walls and ceilings. The stain marks where the water finally found a seam, so the ceiling is opened along the framing until dry members are reached.
Should the rest of the house be looked at?
It is worth raising with the plumber. Where a house was piped in one material in one week, the fittings all reached the same age at the same time. That is not a drying question, but it changes whether an opening is patched now or left accessible, and reopening a ceiling twice costs far more than doing it once.
Why does an October loss take longer than a July one?
Because nothing mechanical is running. Through the summer the cooling system quietly takes moisture out of the whole house, and in the winter the heat does the same. In October neither is on, so the building offers no background drying and the equipment carries the entire load. Three or four extra days is typical.
These questions come from the Temple page.