After the drying
Mold Inspection & Testing in Pearland, TX
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is actually installed outside?
A generator on a concrete pad, a gas supply run to it, and a transfer switch cabinet fixed to the wall beside the meter. It is a permanent installation rather than a portable unit, and it sits close against the building.
Why is the pad a problem?
Because of where it puts the ground. A leveled compacted pad tight against the wall interrupts whatever fall was there, so water arriving during a storm has a flat hard surface beside the foundation instead of a slope away from it.
What is worth checking before the season?
The seal where the conduit and the gas line enter the wall, and whether the pad has settled toward the house. Both are five-minute checks and both are the sort of thing only noticed when the generator is already running in a storm.
This FAQ belongs to the Pearland page; it is repeated here.