After the drying
Mold Inspection & Testing in Frisco, TX
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The slab cannot be cut. How is a leak under it handled?
The line is normally rerouted rather than chased. A post-tensioned slab carries steel tendons under load and cutting it is not a repair decision made lightly, so the supply is rerun overhead or around, and the water already under and in the floor is dried from above. The finish floor comes up so the concrete can be read directly.
What happens to engineered flooring after a loss?
It depends on how long it sat and how the joints reacted. Engineered board is a thin wear layer over a plywood core, and once the joints swell they do not return to flat. The floor is lifted so the slab can dry either way, and boards that have swollen at the edges are replaced rather than relaid.
Why does a May loss take longer than a winter one here?
May is the wettest month at over five inches and the warm season is already running, so outdoor air offers less help and the heat drives moisture deeper into absorbent material. The same loss in a dry, cool stretch would release faster. Equipment is sized to the season rather than to a fixed schedule.
The same questions, in context, on the Frisco city page.