After the drying
Mold Inspection & Testing in Johnson City, TN
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why does one end of the crawl read so much worse?
Because it is a different space. The ground falls away under the house, so the crawl is six feet at one end and knee height at the other, and the shallow end has almost no air movement and the most ground contact relative to its volume. The same house has two conditions under it.
Can the shallow end be worked at all?
With difficulty, and that shapes the whole job. There is not enough height to work in it properly, so material comes out slowly and equipment has to be positioned from the deeper end and ducted along. It is the part that takes the longest and the part people most often leave.
Where does water collect down there?
At the deep end, because everything falls that way. Water reaching the crawl from any point runs to the lowest part and stands there, which is also the part that is easiest to reach and to pump. The shallow end stays damp rather than wet, which is the harder problem of the two.
These questions come from the Johnson City page.