After the drying
Mold Inspection & Testing in Mitchell, SD
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is the well around the basement window?
A curved sheet of pressed steel set into the ground against the foundation, holding the soil back so that a window below grade can still have daylight and air. It is a liner rather than a structure, and it is only as good as the metal.
Why does the liner rust out at the base?
Because that is the part permanently in wet soil. The exposed upper section stays reasonable for decades while the buried lower edge rusts through, so the well looks serviceable from above while the soil behind it is coming in underneath.
What does a proper repair involve?
Digging the well out, putting in a new liner and, more importantly, a drain in the base of it connected to something. Most of these never had a drain at all, which is why they fill, and a new liner without one rusts out the same way.
These questions come from the Mitchell page.