After the drying
Mold Inspection & Testing in Sunbury, PA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Where does the downspout actually go?
Into a pipe buried at the base of the wall, which was meant to carry the water out to the street or a drain. In houses of this age those runs are original and many of them have collapsed or silted up, so the water goes into the ground right beside the foundation instead.
What test shows whether the buried line is working?
Putting water into the downspout and watching what happens at the bottom, which is usually the whole of it. If it backs up, surfaces at the base of the wall or simply disappears without reaching the outlet, the buried run is not doing its job. It takes a few minutes.
What stops a buried downspout line feeding the wall?
Taking the water somewhere else, which usually means bringing the downspout above ground and running it clear of the building rather than excavating the original line. It is inexpensive and it removes a source that has been feeding the foundation for decades.
This FAQ belongs to the Sunbury page; it is repeated here.