After the drying
Mold Inspection & Testing in Johnstown, PA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is the brick-patterned siding?
Asphalt sheet, stamped and colored to look like brickwork and nailed straight over the original wood siding. It was cheap, it went on fast, and it covered a lot of houses in this part of the state. Almost all of it is eighty years old now.
Why does it fail all at once?
Because it ages by becoming brittle rather than by wearing thin. For decades it does its job, and then it reaches the point where a freeze cracks it and the cracks do not close again. After that, a single wall can open up over one or two winters.
What is behind the asphalt sheet?
The original wood siding, usually wet. That is the part that matters, because the asphalt sheet held water against boards that were never meant to stay damp, so the condition underneath is frequently worse than the surface suggests and has to be opened to know.
This FAQ belongs to the Johnstown page; it is repeated here.