After the drying
Mold Inspection & Testing in Easton, PA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Can the hardwood be saved or does it come up?
It is often saved, but only if the drying starts on the first day. Strip flooring cups as it takes water and flattens again as it gives it back, so the aim is to pull moisture through the boards before the cupping sets. Once a floor has stayed cupped for a week it is generally sanded or replaced rather than dried.
What is a drying mat and why is it used on these floors?
It seals to the surface and pulls air through the boards and the gap below them, which is the only way to reach the space between the finish floor and the planks. Left to dry into the room, the top face closes up first and locks the water underneath it in the joint, where it will sit for months.
Why is the cellar ceiling wet when the spill was upstairs?
Because the subfloor is planks with open joints rather than a continuous sheet. Water that passes the finish floor runs along the boards and drops through the first gap it finds, which can be several feet from where it landed. The wet patch below is a poor guide to what got wet above.
These questions come from the Easton page.