After the drying
Mold Inspection & Testing in Portland, OR
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The rain runs from October into May. Does the equipment stay out longer here?
It runs longer than the same loss would elsewhere, because the outdoor air is no help for most of the year. Nothing freezes here, so the ground stays saturated through the wet months and the air stays cool and damp, which means the dehumidifier does all the work rather than sharing it with dry outdoor air. A week is ordinary in December; the same loss in August is a few days.
Does the crawl space need drying if the leak was upstairs?
Usually yes, because the water ends up there. A leak on an upper floor runs down inside the walls and finishes in the crawl, where the ground is already damp and the insulation holds it against the subfloor. The contractor pulls the wet batts, seals and dries the crawl, and reads the joists and subfloor from below until they hold the standard.
Can plaster in an old bungalow be dried without tearing it out?
Often, if it is reached early and the readings move. Plaster on lath is dense and gives up water slowly, so the contractor drills at the base to get air behind it, keeps the room sealed and dehumidified, and reads the lath rather than the surface. Plaster that has gone soft or lost its keys comes out; the rest is dried in place over a longer run.
These questions come from the Portland page.