After the drying
Mold Inspection & Testing in Eugene, OR
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What was the south glazing for?
Solar heating. The idea was that a large glazed south wall would collect winter sun and a heavy floor inside would store it, reducing the heating needed. It was widely built here in that period, and the principle works better in a sunnier climate.
Why is so much of it failing now?
Because it is all the same age. Sealed units have a life of twenty to thirty years, and a wall of them installed at once reaches that point together, so a house can go from one failed pane to half the wall inside a few seasons.
What happens at the floor below it?
It takes the water. The heavy slab or tile floor that was meant to store heat runs right up to the glazing, so water getting past a sill soaks into a thick porous floor rather than running across a surface. That dries slowly and from one face only.
Read it with the local conditions on the Eugene page.