After the drying
Mold Inspection & Testing in Findlay, OH
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is the insulation coming out rather than drying?
Because it holds many times its own weight in water and gives it back very slowly, and while it is up there it is pressed against the underside of the floor. Even where a batt would eventually dry, leaving it keeps the subfloor wet for weeks. It comes out first and the structure is read afterwards.
What is the state of the crawl space before a loss?
Humid, particularly in early summer. The wettest month lands in warm weather, and a crawl space is the coolest part of the building with the most exposed ground, so it carries moisture as a normal condition. That baseline is measured at the start, because it is what the drying works against rather than a dry starting point.
Does the floor above have to come up?
Usually not, and that is the reason for working from below. With the insulation cleared the underside of the subfloor is exposed directly and air can be moved across it, which dries the assembly from the side the water is on. The floor upstairs only comes up where the covering itself was wet or the readings do not fall.
Read it with the local conditions on the Findlay page.