After the drying
Mold Inspection & Testing in Canton, OH
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why does a parged wall read dry when it is not?
Because the coat is separated from the stone. A meter on the surface reads the cement skim, and that skim can be perfectly dry while water runs down the face of the stone an inch behind it. The reading describes the layer you are touching rather than the wall itself.
How is the actual condition established?
By sounding the wall and reading it deeper. Tapping along the coat shows where it has come away, since a hollow section rings differently from a bonded one. Where that is found, the coat is opened at a low point to see what is behind it, which is usually more informative than any surface reading.
Does the coat have to come off?
Where it has lost its bond, yes. A hollow coat traps water against the stone and stops the wall drying at all, so leaving it makes the drying job impossible rather than merely slower. Where it is still solidly attached to the wall, it can stay and be metered through.
The same questions, in context, on the Canton city page.