After the drying
Mold Inspection & Testing in Rome, NY
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is behind the low wall in the upstairs room?
A triangular space running the length of the house between the roof slope and the floor. It is inside the building but outside the heated part, and it usually carries pipe or duct runs. When something in there fails, the water is in a cold void with no air movement and no easy way in.
Why does a loss in there take so long to show?
Because nothing about the space encourages it to appear. The void is cold, closed and unvisited, so water can run along the floor framing for days before it reaches a ceiling below or a wall that anyone sees. By the time it shows, the extent is set by how long it ran rather than by the size of the failure.
Does the wall have to be opened to dry it?
Nearly always. A hatch, where there is one, gives access to a foot or two and no more, and moving air into a long cold void through a small opening does very little. The knee wall comes off along the wet run so the space can be cleared, read and dried as an open assembly.
The same questions, in context, on the Rome city page.