After the drying
Mold Inspection & Testing in Port Jefferson, NY
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
One wall is soaked and the opposite one is dry. Is that normal?
It is what a stepped house does. The uphill wall is buried against the slope and takes ground water and runoff; the downhill wall is open to the air and behaves like any above-grade wall. They are read separately rather than averaged, and the equipment is weighted toward the buried side so the room finishes together.
The lowest level is finished. How much comes off?
Whatever is holding water against the buried wall. Framed partitions and furring fixed to masonry leave little or no gap, so water sits where room air cannot reach it. The finish comes off along the wet section, the wall is dried exposed and read at the base, and it is refastened only once those readings hold.
The rain was weeks ago and it is still wet. Why?
Because the hill is still draining. Ground on a slope keeps delivering water to the uphill wall for a long time after the storm, so the wall is being resupplied while the equipment works. That shows as readings that fall and then stall. It is worth knowing whether the water is still arriving before more equipment time is spent.
These questions come from the Port Jefferson page.